Skip to content

Controlling the laptop from the wall

From MT Screencast 26.11.1, people at the wall can touch the cast picture to control the laptop that shares it: tap, drag and use several fingers, as on a touch screen. It works with MT Caster 26.11.1 or later for Windows and MT Caster 26.11.3 or later for Linux, and only when the person casting allows it.

On the laptop

While sharing, open MT Caster's tray menu and tick Allow people at the wall to control this PC. It is off at the start of every share, and it turns off again when you change what you share or stop sharing. Untick it at any time to stop control at once.

Windows

  • Whole screen: touches go to the shared screen.
  • One window: touches go to that window only where it is on top. Where another window covers it, touches are ignored.
  • Windows does not let MT Caster control apps that run as administrator.

Linux

When you start sharing, the desktop's sharing dialog asks for two things at once: what to share, and whether to allow remote control of the laptop (on Ubuntu's GNOME, the Allow Remote Interaction switch). Allowing it there lets MT Caster offer control; the wall still cannot touch anything until you tick the menu item.

  • The menu item appears only when the desktop allowed remote control for this share. If you switched it off in the dialog, or the desktop has no remote-control portal, the item is not shown and sharing works as before. To be asked again, choose Change what I share.
  • If you tick Remember This Selection in GNOME's dialog, later shares start without the dialog, with the same choice. MT Caster does not let it remember a share without remote control, so the next share asks again.
  • Whole screen: touches go to the shared screen.
  • One window: touches go to where the window is on the screen. Linux does not tell MT Caster which window is on top, so where another window covers the shared one, the touch reaches that other window. Keep the shared window in front.
  • If the desktop allows a mouse but not a touch screen, one finger moves the pointer and clicks; other fingers are ignored.

On the wall

  1. Place MT Cast on the canvas and pin it.
  2. Tap the widget's hand icon and switch Enable remote touch on.
  3. Touch the cast picture.

Only touches made on this wall reach the laptop. People at other sites that share the canvas cannot control it.

How it is set up

Canvus serves each video input's touches on a local port. The companion gives MT Cast a fixed one, [remote-touch] port + 90: 5100 with Canvus's default (inputs 2 to 4 use 5101 to 5103). Canvus reads the port when it starts, so on a new installation MT Cast uses the port Canvus chose until Canvus restarts; touch-back works in both cases. If you change the port in the widget's dialog, the companion follows it.

On Ubuntu, where Canvus's remote touch would otherwise do nothing (no server-ip and no network interface em1), the companion adds interface=lo under [remote-touch] in Canvus's settings file, with a dated comment. This keeps the touch port on the wall computer itself. It never changes a remote-touch setting that is already in use, for example for HDMI laptops with the remote touch app.

The companion's status page shows the touch state for MT Cast, for example "waiting for Canvus to serve port 5100" before remote touch is switched on.

Removing MT Screencast

Removing the package takes out the companion's own changes to the system Canvus settings and the access it gave itself to Canvus's ports file. The MT Cast entry in a user's remote-touch-ports.ini stays; it is harmless and is used again if you reinstall.